Description

Product Specification:

Type: Stabilizer 7-Channel (End Pin) DSMP (DSMX/DSM2 compatible) with Diversity Antenna Number of Channels: 7 Modulation: DSMX Compatible (Also DSM2 backward Compatible) Band: 2.4 GHz Dimensions: 38(L) x 28(W) x 9(H) mm Weight: 8.65g Voltage Range: 3.45 – 8.4 V

Highlights:

True diversity dual antennas with an independent processor for monitoring signals on both antennas

Antennas extended for carbon fuselage/metallic structure installation

7-Channel receiver when the stabilizer is disabled (AUX2 located at the bind position)

Supports Flaperon by switching J6 to the on position while setting the Spektrum transmitter wing type as Flaperon

Gear channel for remote stabilizer on/off

Remote master gain on-the-fly adjustment on AUX3.

How Dual Antennas Work: An independent processor monitors incoming signals and chooses the appropriate antenna for reception. This allows for 2 different locations for installing the antennas along with different orientations. Satellites are no longer needed for receiver diversity. This greatly reduces weight with increased overall reliability in comparison to the use of a primary receiver with a satellite receiver.

Using the Stabilizer as a 7-Channel Receiver:

Turn off J1 to J6

Follow the normal binding procedure by inserting the bind plug into the bind location and enabling binding on the transmitter

The bind location will become the 7th channel. Use an ESC with BEC on the throttle channel for supplying power to the servo.

Understanding the Lemon Rx Stabilizer (Showing Top-Pin Version):

Install location of Lemon Rx Stabilizer:

Direction of Servo Movement with Changes in Direction when Stabilizer is Enabled:

Setup Instruction: Step 1 – Glue your stabilizer along the C.G. Flipping the stabilizer for the required installation is fine with the appropriate J1 to J3 axis correcting direction adjustment. Step 2.1 – (No Flaperon for Fixed Wing/Delta/V-Tail) Disable any mixing on your Spektrum transmitter and choose the correct wing type by setting J4 and J5. Step 2.2 – (Flaperon for Fixed Wing) Disable any mixing and enable Flaperon on the Spektrum transmitter. J4, J5, and J6 are in the on position. Step 3 – The stabilizer already has a built-in Spektrum compatible receiver and will work without a satellite. Insert the bind plug into the bind location and power on the unit. The LED indicator will flash quickly. Turn on your transmitter to bind mode for binding. If binding is successful, the LED indication will stop flashing and become solid. Step 4 – Sub-trim and set stick directions with the Spektrum transmitter on all channels as necessary. Upon trimming, toggle the Gear switch twice in 1 second to allow stick centering detection, which is required for optimizing the stabilization. The Gear switch is used to switch between manual or stabilization control. A green + red LED indication means no stabilization while a solid green LED means stabilization is enabled. If AUX3 is available on your transmitter, remote master gain tuning for all 3 channels will become available. However, during setup, AUX3 should be in its center position. Step 5 – Adjust the 3